• +971 4 263 7073, +971 52 864 1667, +971 56 515 2787
  • info@sancouae.com
Drain Line Jetting (Pipe Line Block Remover)

Drain Line Jetting (Pipe Line Block Remover)

SANCO uses typical drain line jetting systems for cleaning and maintaining drain and sewer lines. Over time fats, oils, and grease FOG coats, thickens, and accumulates inside pipelines, leading to the hazardous and costly ow of waste grease into drainage lines and sewer lines. Clogging of drains may stop your business from running daily operations and even cause the business to close down. We offer combination of snaking rooting and hydro jet plumbing service to suit the best solution for all draining problems. Our special treatment removes the clogs and blocks that occur in the drain line thereby allowing for easy ow of waste water through the drainage.


1:Hydro Jet Plumbing/Hydro Jetting

High Pressure Water Jetting

Hydro jetting uses high water pressure to clean pipes removing all build up that has accumulated inside the pipeline. To prevent your main lines and drains from clogging or to remove pipe build up hydro jetting is highly suggested to be done once every 3 to 9 months. Depending on the business traffic flow and the consumption of waste and grease this may vary from one company to another.

1: Hydro Jet PlumbingHydro Jetting

High Pressure Water Jetting
Powerful penetrating nozzle cuts through grease and ice
Draine line jetting
Wide spray nozzle cleans the inside of pipes thoroughly
Drain line block removal dubai
Spring leader nozzle gets hose around tight bends and P-traps
Drain line maintenance dubai
Rotary nozzle scours walls of pipes leaving them crystal clear

Hydro jetting plumbing process involves inserting a high pressure stream of water flowing at 15-18 gallons per minute into the pipelines to clear waste build up.

2: Rooting / Snaking


In many cases rooting can unclog the drains by cutting through the blockage. While hydro jetting uses high water pressure to clean the pipelines, rooting uses traditional steel cable machinery to cut out blockages. Depending on the type of line different snake size is used for better results. Many plumbers do not offer hydro jetting due to the high cost of hydro jet machines. Therefore, snaking a line may fix the problem for the time being but if the problem continues to arise; most likely it is time for the line to be hydro jetted.